TL866CS升级TL866A的方法英文版

shangdawei · 发表于 2017-4-20 21:54:40

Here's a quick guide to upgrading your TL866 programmer from the CS version to the A version.
This operation enables use of the ICSP port (which is easily soldered in).

游客，如果您要查看本帖隐藏内容请回复

1: Install the Programmer's software in C:\MiniPro (I used the current version included in the .zip).
2: Plug in Programmer (hope you c[/hide]hose to install the USB driver in the above step).
3: Run Programmer Software and look at the very bottom line. It should show your version TL866CS.
4: Exit back to Desktop.
5: Run the TL866.exe program.
6: Click the browse button [...] and browse for your update.dat file in C:\MiniPro.
7: Select the "Firmware Dumper" button, and hit the "Reflash" button
8: Click "Advanced", then select "A Bootloader", then hit "Write"
9: Unselect "Code protection bit", then hit "Write"
A: Hit OK to exit that menu, then select "TL866A firmware" and hit "Reflash"
B: When reflash is done, hit "Reset", wait, and hit "Reset" again.
C: Exit the TL866.exe program.
D: Run Programmer software again, look at bottom line. It should say TL866A.
E: Have fun

Please note that I performed the above steps while I was typing this,
so I am quite certain everything is correct.

Edit: There are some confirmation prompts that I skipped here because they're obvious.
Just say "Yes" or "OK" on all such prompts.